Chapter 4: Using SConfigurator for
Configuration
Once you have connected all the equipment to the device, you can begin configuring the device to ensure
that it can communicate with the attached devices and with a video management software over the network.
In order to configure the device, you first need to obtain the IP address using SConfigurator.
SConfigurator is a PC-based administration tool that you can use over any TCP/IP network.
CAUTION: Any changes made using the video management software will override the changes made using
SConfigurator or the Web Interface.
The following topics are discussed:
Setting SConfigurator 53
Discovering Devices 54
IP Address Configuration 55
Configuring the Serial Ports 57
Setting the H.264 Encoding Mode for the S1816e-SP or S1816e-SR 61
Setting the Video Standard 62
Video Profile 63
Configuring the Device Video Properties 64
Configuring the Input Properties 65
Setting the SNMP Properties 66
Audio Properties 68
Chapter
4
To Next Page
Loading...
Need help?
General
