Setting the SNMP Properties
Simple Network Management Protocol (SNMP) is a protocol used by network management
systems to manage network equipments from a central location. The S1800e devices are SNMP-
compliant and store data about themselves in Management Information Bases (MIBs) and return
this data (SNMP Traps) to the SNMP requesters.
► Perform the following steps:
1. Start the Web Interface.
2. From the tree, select Configuration >SNMP.
3. In the SNMP panel, select the Enabled check box enable the SNMP service.
4. In the System Location box, type the location for the Edge device.
5. In the System Contact box, type the e-mail address of the network administrator.
6. In the Primary Trap Destination Address box, type the IP address of the primary server that
will receive the SNMP Traps.
7. In the Backup Trap Destination Address box, type the IP address of the backup server that
will receive the SNMP Traps in case the primary server is unavailable.
8. In the Community Name box, type the name of the group where you want the edge device to
be a member.
NOTE: The Edge device will only respond to requests from management servers that belong to the
same community.
9. In the User Name box, type the name of the SNMP user.
10. In the User Authentication Type list, select the authentication algorithm for SNMP requests.
You can select from the following:
Chapter 5: Using the Web Interface for Configuration
Verint Video Intelligence Solutions
90
To Next Page
Loading...
Need help?
General
