Verint Nextiva S1808e-A - Recording to Storage Device

6. In the Transparency box, type a value to the set transparency level of the text on the monitor.
7. From the Tiles tab, for each tile, set the following:
a. In the Starve Mode list, select what to display on the monitor when there is no video. You
can select from:
Screen Saver
Black
Last Decoded Image
b. In the Show Transmitter Name list, select whether or not to show the device name.
Choose from the following
c. In the Transmitter Name box, type the name you want to show.
8. Click Apply.
Recording to the Storage Device
The encoders now support storage on the edge - a failover mechanism that ensures video is
recorded in case connection with the management software is lost. The single- and dual-port
encoders support microSDcards with a maximum capacity of 32 GB. The mulitport encoders
support one USB drive.
NOTE: The S1816e-SRdoes not support recording to a USBdrive.
► Perform the following steps:
1. Start the Web Interface.
2. From the tree, select Configuration >Storage.
3. Select one of the following:
No recording: No recording is done on the storage device.
Upon VMS disconnection: Recording is done when the device is disconnected from
Nextiva VMS. Select from one of the following.
Chapter 5: Using the Web Interface for Configuration
Verint Video Intelligence Solutions
102