6. Set the value for the following settings:
Input Type: Select Line-in or Mic (with pre-amp).
Input Compression: Select Uncompressed PCM (128 kbps) or μ-LAW (64 kbps).
Gain State: Select Enabled or Disabled.
Gain Level: Move the slider to the left or right.
Bias State: Select Enabled or Disabled.
Bias Level: Move the slider to the left or right.
7. Click OK.
Setting the Audio Decoder Properties
The audio output properties allow you to set the Gain to increase the amplitude of the input signal.
► Perform the following steps:
1. Start SConfigurator.
2. Select the Units tab, then click Discover.
3. Select the Nextiva device, and click Configure.
4. In the tree view, click Unit >Audio >Decoder.
Chapter 4: Using SConfigurator for Configuration
Verint Video Intelligence Solutions
70
To Next Page
Loading...
Need help?
General
