7.5.1 Identify the Sensor as Connected 62
7.5.2 Change Sensor Label (Name) 63
7.5.3 Change Units Label 63
7.5.4 Change 4 mA Value 64
7.5.5 Change 20 mA Value 64
7.5.6 Change Offset Value 65
7.5.7 Define Sensor as Alarmable or Event 65
7.5.8 Set Up Alarmable Sensors in Latched or Unlatched Mode 66
7.5.9 Change Low Setpoint 66
7.5.10 Change High Setpoint 67
7.5.11 Set Up Delay Time 68
7.6 Setup System - Setup Zones 68
7.6.1 Set Up a Zone 69
7.7 Setup System - Setup Outputs 70
7.7.1 Define Output as Normally Open or Normally Closed 71
7.7.2 Define Operating or Standby Mode 71
7.7.3 Enable or Disable an Output Device in Alarm Status 72
7.7.4 Enable or Disable a Device during Emergency Power Operation 72
7.7.5 Configure Output for Loss of Power (“Fail-Safe”) 72
7.8 Setup System - Setup Modem & Pagers 72
7.8.1 Modem Setup - Initialization String 73
7.8.2 Modem Setup - Additional Features (Service Terminal Interface only) 75
7.8.3 Pager Setup - Pager Number and PIN 78
7.8.4 Pager Setup - Communications Check (Service Terminal Interface only) 80
7.9 Setup System - Setup System Info 82
7.9.1 Change Password 83
7.9.2 Change Date & Time/Automatic Daylight Saving Time 84
7.9.3 Setup Site ID 85
7.9.4 Connect Battery 85
7.9.5 Backup and Upload Configuration File (Service Terminal Interface only) 86
7.9.6 Setup Serv Ph Num - Enter Phone Number 88
7.9.7 Setup Serv Ph Num - Communications Check (Service Terminal Interface only) 89
7.9.8 Factory Defaults 91
7.9.9 Perform Firmware Update (Service Terminal Interface only) 91
7.9.10 Initiate Remote Alarm Test (Service Terminal Interface only) 93
7.10 Setup Operation 95
7.10.1 Turn Automatic Sequencing On or Off 96
7.10.2 Turn Standby Testing On or Off 97
7.10.3 Specify Failed Standby Response 98
7.10.4 Specify Hold Delay Time 99
7.10.5 Specify Restart Time 99
7.10.6 Specify Staging 100
Vertiv | Liebert® AC8 User Manual | v
To Next Page
Loading...
