WAGO 750 Series User Manual

Board Support Package (BSP) • 57
Scope of delivery
WAGO-I/O-SYSTEM 750
Linux Fieldbus Coupler
The /linux directory
This directory contains the 2.6 Linux source code as well as the ARM
toolchain for x86 systems
• sources
The source code for the 2.6 Linux kernel.
The source code is unpacked by the install.sh script into the home
directory of the current user.
• toolchain
ARM toolchain for x86 systems.
The install.sh script requires super user privileges.
The /uboot directory
This directory contains the source code as well as the toolchain of the boot
loader (uboot) for x86 systems.
Changes to the boot loader should only be made in some rare exeptions.
• sources
The uboot source code.
The source code is unpacked by the install.sh script into the home
directory of the current user.
• toolchain
Uboot toolchain.
The install.sh script requires super user privileges.

WAGO 750 Series Specifications

General

Protection Class	IP20
Bus Couplers	PROFIBUS, CANopen, Ethernet
Modules	Digital Input, Digital Output, Analog Input, Analog Output
Mounting	DIN rail mounting
Voltage Supply	24 V DC (typical)
Communication Protocol	Depends on the bus coupler (e.g., PROFIBUS, CANopen, DeviceNet, Ethernet)
Digital Input Channels	Varies by module (e.g., 8, 16 channels)
Digital Output Channels	Varies by module (e.g., 8, 16 channels)
Analog Input Channels	Varies by module (e.g., 2, 4, 8 channels)
Analog Output Channels	1, 2, 4 channels (depending on module)
Width	12 mm, 24 mm (typical module widths)
Number of Channels	Varies by module type
Current Consumption per Channel	Varies by module type