Wallace Perimeter Security ALPHA - Page 17

Alpha/Delta (Kinetic Operator) Installation and Maintenance Manual Revision 1 - MAY 2023
17
ALPHA/DELTA INSTALLATION & MAINTENANCE CHECKLIST
ALPHA/DELTA INSTALLATION AND MAINTENANCE
CHECKLIST
Checked Good Needs
Aenon
N/A
23� Gate Handing
From the secure side of the gate, record if it slides
to the le or to the right:
24� Fire Department Override
If enabled, write YES in space provided. If not
enabled, write NO in space provided:
25� Response to AC Power Failure
Record whether AC Power Loss seng is set to
AP0, AP1, AP2 or AP3:
26� SmartDC Controller – Baeries
Check baeries for physical wear and corrosion
on leads. Clean if needed. Test baery input and
output voltage via the SmartDC circuit board and
record.
Baery input voltage:
Baery output voltage:
Baeries should be replaced every 2 years.
27� SmartDC Controller – Soware Version
Check the soware version on the SmartDC board.
If not the latest version, contact the Wallace
Perimeter Security service team to download new
version, update and record new version number:
28� Wiring
All eld wiring should run in the provided wiring
ducts. Power supply wiring should be secured
safely in appropriate clips.