WinGD X72 - Page 321

Operation
4003−2/A0
Winterthur Gas & Diesel Ltd.
1/ 7
Control Diagram
1. General 1..........................................................
2. Area Codes in the Control Diagram 1................................
3. System Codes 1....................................................
4. Process Codes − Description 2......................................
5. Sensors and Transmitters 5.........................................
6. Actuators and Valves 6.............................................
1. General
The identification of parts include those given in: 4003−1, 4003−2, 4003−3,
4003−4, 4003−5, 4003−6, 4003−7, 4003−8, 4003−9, 4003−10 and 4003−11.
2. Area Codes in the Control Diagram
The area codes in the control diagram are shown in Table 1.
Table 1: Area Codes
A − Control air supply unit
B − Servo oil supply
D − Servo oil supply
E − Valve unit for start
K − Local control panel
3. System Codes
The system codes are shown in Table 2.
Table 2: System Codes
Code 10 − Fuel System
Code 20 − Oil System
Code 25 − Cylinder Lubrication System
Code 30 − Starting Air System
Code 35 − Control Air System
Code 40 − HT Cooling Water System
Code 48 − Cylinder Cooling Water System CCO
Code 50 − Exhaust Gas System
Code 70 − Miscellaneous Systems
Code 80 − Automation System
Code 99 − Pipe Diagram
Code 900 − Engine Room
2016-01
Identification of Parts