SmartPAC 2 User Manual 1126700
Table of Contents xv
How To Use This Manual
This manual shows you how to install, set up, program, operate, and troubleshoot SmartPAC
2 including the optional DiProPAC and ProCamPAC modules.
Chapter 1 provides an overview of the operation and features of SmartPAC 2.
Chapter 2 shows you how to install SmartPAC 2.
Chapter 3 shows you how to use the SmartPAC 2 displays and keyboard.
Chapter 4 shows you how to use SmartPAC 2 in Initialization mode, which is the mode you
select to make settings that apply to SmartPAC 2 operation for all tools.
Chapter 5 shows you how to use SmartPAC 2 in Program mode, which is the mode you select
to program settings that apply to SmartPAC 2 operation for individual tools.
Chapters 6 shows you how to use SmartPAC 2 in Run mode, which is the mode you select to
run the press and make minor adjustments to programmed settings.
Chapter 7 provides explanations of the messages that display on the SmartPAC 2 front panel
when a fault condition occurs or a counter preset is reached, and shows you how to correct
SmartPAC 2 faults.
Appendix A shows you how to use the optional PM (Preventative Maintenance) Monitor
available with SmartPAC 2.
Appendix B shows you how to upgrade SmartPAC 2 firmware.
Appendix C shows you how to install and use the SmartView remote viewing utility.
Appendix D provides instructions in upgrading from an original SmartPAC to a SmartPAC 2.
Appendix E shows you how to install a replacement SmartPAC 2 board.
Appendix F shows you how to report downtime and scrap to Wintriss’s ShopFloorConnect
Asset Utilization Software (SFC).
Appendix G shows you how to report downtime and scrap to Wintriss’s Line Efficiency
Tracking Software (LETS).
The Glossary provides definitions of some of the terms used in the manual that may be
unfamiliar to you.
Setup sheets at the back of the manual provide forms on which you can maintain a record of
Initialization and Program settings for your SmartPAC 2.
Wiring diagrams (Figures 1 through 5) following the Setup sheets provide wiring connections
for SmartPAC 2, DiProPAC, ProCamPAC, and the SmartPAC 2 loopback test.
To Next Page
Loading...
Need help?
General
