1126700 SmartPAC 2 User Manual
B-8 Updating SmartPAC 2 Firmware
9. Double-click on the My Computer icon on your desktop, and when the “My Computer”
window opens, navigate to the folder in which you placed the unzipped SmartPAC 2
firmware file. (The contents of the unzipped file are in a folder named SP2nnnnnnnn,
where nnnnnnnn is the serial number of your SmartPAC 2.)
10. Insert a USB disk into your computer’s USB port. Wait a few moments for it to be
recognized.
• If your computer is already set up to use a USB disk, the USB drive (usually named
“Removable Disk” with a drive letter next it) will appear in the “My Computer”
window.
• If you have never used a USB disk on your computer, you will be prompted with a
message saying, “New hardware has been found.” Follow the on-screen instructions to
find and install the proper drivers for your USB disk. For assistance, contact your
information technology staff.
11. With both the SP2nnnnnnnn folder and the USB “Removable Disk” icon visible in “My
Computer” windows, copy the SP2nnnnnnnn folder to the USB disk.
12. Stop the USB disk, using the “Unplug or Eject Hardware” utility on your computer. (The
“Unplug or Eject Hardware” icon is often displayed on the far right side of the Task Bar.)
13. Remove the USB disk from the USB drive.
To install downloaded firmware from the USB disk to SmartPAC 2, follow the instructions in
Installing Updated Firmware from USB Disk to SmartPAC 2, page B-2.
Be sure to stop the USB disk before removing it from the computer. If you don’t, valuable
data on your computer may be corrupted or lost.
If you are using Windows XP, you do not need to “unplug” or “eject” the USB disk.
To Next Page
Loading...
Need help?
General
