1126700 SmartPAC 2 User Manual
1-8 Introduction
Options
(continued)
AutoSetPAC* or WaveFormPAC* 10.25 x 12 x 4 in. (260 x 305 x 102 mm)
2 or 4 strain link inputs
Ability to store high, low, and repeatability setpoints with tool number
Displays, adjusts, recalculates “auto” setpoints and displays actual load
Displays and saves load signatures
With WaveFormPAC: Up to 4 windows to monitor tonnage at points other
than the peak
WPC 2000*
(Wintriss Clutch/Brake Control) 16 x 16 x 9 in. (406 x 406 x 228
mm)
Ability to set press parameters using keyboard
Easy-to-understand error diagnostic messages on display
Stroke selector switch
SFI ServoFeed Interface integrates servofeed
RamPAC* 10.25 x 12 x 4 in. (260 x 305 x 102 mm)
Automatically sets shut height and counterbalance and cushion pressures
ProPAC*
12.3 x 14 x 4.3 in. (312 x 356 x 109 mm)
Provides up to 16 analog, NPN or PNP inputs
Ability to store high, low, and repeatability setpoints with tool number
Display and adjust manual or auto setpoints and display actual values
Monitor in-die dimensions and other process parameters
SBR Provides capability to back up tool settings to a Windows laptop PC.
Requires purchase of SBR software.
USB Disk Backup Enables backup of programmed tool settings to USB disk
Info Center With this option Setup sheets and other press information stored
on a central server can be displayed on networked SmartPAC 2s
High Speed (HSP) Required for presses with speeds higher than 800 SPM;
handles speeds from 14-1600 SPM (see Speed and Accuracy, above)
Bilingual* (English/Spanish) status/adjust menus
Preventive Maintenance (PM) Monitor Tracks selected press functions
requiring scheduled maintenance and alerts the user when maintenance is
due
PLC Interface Enables SmartPAC 2 to transmit additional tool settings to a
Programmable Logic Controller for press automation and auxiliary functions
ShopFloorConnect Asset Utilization Software (SFC) or Line Efficiency
Tracking Software (LETS) Provides capability for production information
from SmartPAC 2 to be downloaded to SFC or LETS data collection software
for generation of OEE and other reports. Requires purchase of SFC or LETS
software.
3rd Party Comms This option allows SmartPAC 2 to transmit real-time and
status information to external software for reporting and other tasks
* Consult product user manual. DSI 2: #1121900; AutoSetPAC: #1101600; WaveFormPAC:
#1109100; WPC 2000 (SmartPAC 2 with WPC 2000): #112860000; RamPAC: #1115200;
ProPAC: #1117500; Bilingual (English/Spanish): #1130600.
Table 1-1. SmartPAC 2 Specifications (Cont.)
To Next Page
Loading...
