Xerox B310

Action Yes No
Step 4
1 Remove the fuser. See Fuser
removal.
2 Make sure that the fuser entry
guide is free of waste toner
and dust.
Clean the fuser entry guide with a
toner vacuum and cloth. Do not
use compressed air.
Does the problem remain?
Go to step 5. The problem is solved.
Step 5
Replace the fuser.
Does the problem remain?
Contact the next level of support. The problem is solved.
SSoolliidd BBllaacckk PPaaggeess CChheecckk
Note: Before performing this print quality check, print the Print Quality Test Pages. From the
control panel, navigate to Settings > Troubleshooting > Print Quality Test Pages, and then
perform the initial print quality check. See Performing the initial troubleshooting check .
Action Yes No
Step 1
Check if the printer is using a
genuine and supported Xerox
toner cartridge.
If the printer is using a third-party
cartridge, then refer the users to
their cartridge supplier.
Is the printer using a genuine and
supported Xerox toner cartridge?
Go to step 3. Go to step 2.
Step 2
Insert a genuine and supported
Xerox toner cartridge.
Does the problem remain?
Go to step 3. The problem is solved.
50
Xerox
®
B310 Printer
Service Manual
Diagnostics and Troubleshooting