Xerox Phaser 7760 - Page 419

January 2010
2-383
Phaser 7760 Color Laser Printer
OF 10-16, OF 12-1
Status Indicator RAP’s
Revised
OF 10-16 Noise/Odor RAP
The machine produces noise or odor.
Procedure
The machine produces noise.
YN
Then odor is produced.
Identify the source of the odor such as the Fuser (PL 7.1), AC Input Power area (PL 9.1 -
PL 9.3), Paper Trays (PL 2.1), Xerographics (PL 4.1 - PL 6.2). Service as required.
The Left Cover Assembly is free of noise.
YN
Refer to PL 2.8, Exit Roll Shaft, and clean and lubricate the bearings.
Operate machine with covers removed to identify the source of noise. Clean or lubricate the
appropriate component. Operate Motors on sub-system individually to isolate the noise to a
particular mechanism.
OF 12-1 Finisher Problem
There is a problem with the Finisher that does not produce a fault code.
Procedure
The machine is equipped with an Advanced / Professional Finisher.
YN
Refer to the Parts List to repair the Finisher problem.
• Major Finisher Components
• Gate Assembly
• H-Transport
•Covers
• Top Cover and Eject Rolls
• Paper Transportation
• Stapler within Finisher
• Convenience Stapler
• Compiler
•Elevator
• Exit Assembly
• Electrical Components
• Rack Assembly (base)
Refer to the appropriate procedure to adjust the Finisher.
• ADJ 12.2 Finisher Leveling
• ADJ 12.4 Booklet Fold Skew
• ADJ 12.5 BookletFold Position
• ADJ 12.6 Booklet Staple Position (Staple on Fold)
• ADJ 12.7 Booklet Staple Alignment
• ADJ 12.8 Booklet Wrinkle
• ADJ 12.9 Booklet Fold Position (Fine Adjustment)
• ADJ 12.10 Booklet Staple Position (Staple on Fold Fine Adjustment)