3-60 Phaser 8400/8500/8550/8560 Color Printer Service Manual
Error Messages and Codes
X2F Tray 3 pick flag triggered unexpectedly while printer was in a fault state.
X2L Tray 3 pick flag triggered unexpectedly while printer in standby.
X2M Tray 3 pick flag triggered unexpectedly while picking from Tray 2.
X2N Tray 3 pick flag triggered unexpectedly while picking from Tray 3.
X2P Tray 3 pick flag triggered unexpectedly while picking from Tray 4.
X2Q Tray 3 pick flag triggered unexpectedly while picking from Tray 1.
X2R Tray 3 pick flag triggered unexpectedly while duplexing.
X2S Tray 3 pick flag triggered unexpectedly while transfixing.
X2V Tray 3 pick flag triggered unexpectedly while print Drum maintenance cycle
was being performed.
X2W Tray 3 pick flag triggered unexpectedly during printer imaging.
X2X Tray 3 pick flag triggered unexpectedly while exiting print.
1. Ensure ground integrity of the printer, see page 4-65.
2. Ensure the paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the 525-Sheet Feeder.
5. Replace the pivot arm.
X3D Tray 3 pick flag sensor timed out during warm-up.
X3E Tray 3 pick flag sensor timed out during wile printer ready.
X3F Tray 3 pick flag sensor timed out while printer in fault state.
X3L Tray 3 pick flag sensor timed out while printer in standby.
X3M Tray 3 pick flag sensor timed out while picking from Tray 2.
X3N Tray 3 pick flag sensor timed out while picking from Tray 3.
X3P Tray 3 pick flag sensor timed out while picking from Tray 4.
X3Q Tray 3 pick flag sensor timed out while picking from Tray 1.
X3R Tray 3 pick flag sensor timed out while duplexing.
X3S Tray 3 pick flag sensor timed out while paper staged for print.
X3T Tray 3 pick flag sensor timed out while transfixing the print.
X3V Tray 3 pick flag sensor timed out while the printer Drum maintenance cycle
was being performed.
X3W Tray 3 pick flag sensor timed out while printer imaging.
Jam Code Troubleshooting Procedures (Continued)
To Next Page
Loading...
