Xerox Phaser 8500 - Page 288

8-18 Phaser 8400/8500/8550/8560 Color Printer Service Manual
Service Parts Disassembly
Replacement
1. Position the Wiper so both ends are all the way down following
reassembly (see “Wiper Alignment Procedure” on page 6-2).
2. When reinstalling the belt into the wiper clip in 8500/8550/8560 models,
place the belt partly on the clip, and then press the center of the clip with
a small needle-nose plier until the belt is secured in the clip.
N
o
t
e
Later versions of 8500/8550 models serial numbered WYN1xxxxx or
WYP1xxxxx use the wider style Wiper Belt and 8400 model Wiper Blade.
Wiper Clip
Wiper Belt
s8500-082