5. Load and register the paper against the right side of the tray for LEF direction.
6. Load and register the paper against the right side of the tray as depicted below for SEF direction.
7. Adjust the paper guides by pressing in the guide release and carefully moving the Edge Guide
until it lightly touches the edge of the stock in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
8. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings/Tray Properties window displays
on the UI.
9. From the Paper Tray settings/Tray Properties window, enter the correct paper information,
including size, type, weight and, if necessary, paper curl and/or alignment option.
10. Select Confirm or OK to save the information and close the Paper Tray settings/Tray Properties
window.
Postcard Bracket
The Postcard bracket is delivered with the OHCF from manufacturing. The Postcard bracket allows you
to print on smaller size media without requiring post-processing cutting or sorting. The Postcard
bracket specifically accommodates 4 x 6 in. (101.6 x 152.4 mm) SEF media.
119
To Next Page
Loading...
