Number
Component Description
4 Top tray Receives the printed output. Sample sheets also are
delivered here.
Holds a maximum of 500 sheets (13 x 19.2 in., 330 x
488 mm).
5 Circuit breaker switch The circuit breaker switch is located on the rear of the
HCS. This switch automatically shuts off electricity in
the event of electrical failure or a short circuit.
6 Top cover Open this cover to clear paper jams.
7 Stacker tray/cart Collated sets (up to a total of 5000 sheets) are
transported to the stacker tray, which is located on a
movable stacker cart.
8 Front door Open this door to remove paper/printed output.
HCS Circuit Breaker
The HCS circuit breaker is located on the rear of the HCS unit.
1. On or Off Switch
2. Test Button
The circuit breaker switch is normally in the ON position.
Note: When an electrical interruption is detected, the circuit breaker automatically switches off
to discontinue the electrical flow to the HCS. For electrical information, refer to Safety.
148
To Next Page
Loading...
