EasyManua.ls Logo

Xerox Versant 280 Press - Page 173

Xerox Versant 280 Press
375 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Booklets exiting the SquareFold
®
Trimmer device can contain trim remnants or scraps from the
previously trimmed booklet. Static electricity causes this build-up and it is normal. If booklets
contain trim remnants, simply remove and discard them.
The trim feature can be switched on or off. When the feature is on, you can adjust the trim setting
in 0.1 mm (0.0039 in.) increments depending on your requirements for the finished booklet job.
The trim options include the following:
Trimming On/Off: Switch On/Off the Trimming feature. The default setting is Off.
Cut to Size: Use the Left/Right Arrow buttons to decrease or increase the trimmer setting.
Adjustments are made in 0.1 mm (0.0039 in.) increments.
The trim setting is based on:
The number of sheets in the finished booklet
The finished booklet width size
The media type (coated or uncoated)
The media weight
Note: Experiment with various settings to determine the best selections for your job. You may
want to run one or more test prints before running larger jobs for best booklet output.
Note: Trim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20
mm (0.787 in.) of edge material from the booklet. Adjustments less than 2 mm may produce
poor trim quality. Adjustments greater than 20 mm result in no trimming to the booklet edge.
Trim Guidelines
The following table shows various scenarios using different paper weights, media types, and trim
setting selections. Use this table as a guideline when selecting a trim setting for your specific job.
Note: The settings shown in the following table are provided as examples and are not meant
to represent every possible job scenario; again, use this table as a guideline only.
Scenar-
io
num-
ber
Paper Size
Finished
booklet size
Paper weight (lbs./
g/m
2
)
Approximate
trim setting
(mm)
Number of
pages in
finished
booklet
1
210 x 298 mm (8.5
x 11 in.), A4
149 x 210 mm
(5.5 x 8.5 in.)
20 lbs./ 75 g/m
2
130 20
2
210 x 298 mm (8.5
x 11 in.), A4
149 x 210 mm
(5.5 x 8.5 in.)
24 lbs./ 90 g/m
2
125 14
3
210 x 298 mm (8.5
x 11 in.), A4
149 x 210 mm
(5.5 x 8.5 in.)
32 lbs./ 120 g/m
2
135 10
4
210 x 298 mm (8.5
x 11 in.), A4
149 x 210 mm
(5.5 x 8.5 in.)
20 lbs./ 75 g/m
2
125 10
5
210 x 298 mm (8.5
x 11 in.), A4
149 x 210 mm
(5.5 x 8.5 in.)
80 lbs./ 120 g/m
2
135 12
6
250 x 353 mm (8.5
x 14 in.), B4
250 x 176.5 mm
(8.5 x 7 in.)
20 lbs./ 75 g/m
2
172 6
173

Table of Contents

Other manuals for Xerox Versant 280 Press

Related product manuals