Xerox Versant 280 Press - Page 213

3. Grip the staple cartridge by the orange handle and pull it firmly toward you to remove it.
4. Pinch both sides of the staple refill (1)and remove it from the cartridge (2).
5. Insert the front side of the new staple refill into the staple cartridge(1), then push the rear side
into the cartridge(2).
6. Close the front door of the Business Ready Finisher.
Replacing Staples in the Booklet Maker
1. Open the front door of the Business Ready Finisher.
2. Grasp the booklet maker handle and pull the unit toward you until the staple cartridges appear
on the top edge of the device.
3. To remove the staple cartridge from the booklet maker, push down on the staple cartridge handle
as shown, then pull the cartridge out and up.
213