3. Discard all waste from the container.
Important: Be sure to completely empty the container. If any waste or scraps remain, the
container becomes full before a full message displays causing a fault to occur.
4. Return R4 to its original position.
5. Close the finisher front cover.
PR Finisher Plus Maintenance
For information on consumable supplies and maintenance procedures for the PR Finisher Plus, refer to
the following:
• Finisher Consumable Supplies
• Checking the Status of Finisher Consumables
• Replacing the Basic Staple Cartridge (for Side Stitching)
• Replacing the Finisher Staple Waste Container
• Emptying the Hole Punch Waste Container
227
To Next Page
Loading...
