Basic Copying with the Document Glass
1. Open the document feeder.
2. Place the document face down by aligning it as shown in the illustration.
3. Press the Home button on the press UI.
4. Select Copy on the Home window.
5. Select the desired Copy features or options:
• Paper Supply
• Reduce or Enlarge
• Output Color
• 2-Sided Copying
• Original Type
• Lighten/Darken
The features displayed on the main Copy window vary depending on how it is configured by the
administrator.
6. Enter the quantity.
7. Press Start.
Selecting Copy Options for a Third-Party Finishing Device
Read the following list before performing the procedure:
• If your press has an optional, third-party, Document Finishing Architecture (DFA) device attached,
then this profile feature is available and specific copy options may be selected for a job.
• Prior to physically attaching the DFA device to the press, device profiles are created. The profiles
represent the characteristics of your finishing device.
• Refer to the third-party customer documentation for information on setting the profile values for
the specific DFA device attached to the press.
• A profile for the job can be selected from the print server, the print driver on your computer, or the
User Interface (UI). Depending on the DFA device, a maximum of twelve profiles are available.
1. Place your original documents in the document feeder or on the document glass.
2. Press the Home button on the UI.
40
To Next Page
Loading...
