Xerox Versant 280 Press - Page 60

• Build Job
• Sample Job
• Combine Original Sets
• Delete Outside / Delete Inside
Build Job
This feature allows you to change and save settings individually for each document page or stack. You
can then make copies of documents with different settings as one job.
1. Split the hard-copy document into sections for individual programming.
2. On the Home window, select Copy.
3. Select the Job Assembly tab.
4. Select Build Job.
5. Select On.
6. Select Save.
7. Select Build Job again.
8. Program the job requirements for the first segment of the job by selecting and saving the
applicable features from the features shown at the bottom of the Build Job window. After
making selections for each category, select Save. Then on the Build Job window, select Save.
• Copy Output
• Booklet Creation
• Covers
• Annotations
• Segment Separators
• Watermark
• Face Up/Down Orientation
9. Load only the first segment into the document feeder or place the segment on the document
glass one page at a time.
10. Press Start.
When the first segment has finished scanning, the Copy Status screen will appear.
11. Remove the originals from the document feeder or document glass.
12. Select Change Settings.
13. Program the job requirements for the second segment.
14. Load the second segment into the document feeder or on the document glass.
15. Press Start.
16. Repeat the previous steps until all segments of your job have been programmed and scanned.
17. After the last segment has been scanned, select Last Original.
The press will complete the quantity selected.
18. Retrieve the copies from the output area.
60