8. Program the job with the desired Copy features or options.
9. Enter the quantity.
10. Press Start.
11. When you are finished scanning all the documents, select Last Original to complete the job.
12. Retrieve the copies from the output area.
Delete Outside/Delete Inside
This feature allows you to specify the area for omission or deletion and then to copy that area. Keep
the following in mind when you use this feature:
• When specifying multiple areas to delete, it is also possible to overlap and specify an area.
• When selecting Reduce or Enlarge, the areas are reduced or enlarged by interlocking
magnification.
1. Press the Home button on the User Interface (UI).
2. Select Copy on the Home window.
3. Select the Job Assembly tab.
4. Select Delete Outside/Delete Inside.
The Delete Outside/Delete Inside screen appears. By default, Off is selected.
5. Select Delete Outside or Delete Inside.
6. If the originals are 2-sided, select the applicable option:
• Both Sides
• Side 1 Only
• Side 2 Only
7. Select the Area 1 button.
The Delete Outside/Delete Inside Area 1 screen appears. Use this screen to define the first area
for deletion (omission) from the copy output.
8. To define a specific area, enter the two X and Y coordinates within a range 0.0-17.0 inches (0.0-
431.8 mm). Navigate from coordinate to coordinate by selecting each X or Y button:
a. Select the Y1 box and use the numeric keypad on the UI to enter the value for Y1.
b. Select the Y2 box and use the numeric keypad on the UI to enter the value for Y2.
c. Select the X1 box and use the numeric keypad on the UI to enter the value for X1.
d. Select the X2 box and use the numeric keypad on the UI to enter the value for X2.
Clear a deletion area by selecting the Clear Area X (1, 2, or 3) button.
9. Select Save.
10. Select Save again.
11. Select any other desired copy features or options.
12. Enter the quantity.
13. Press Start.
14. Retrieve the copies from the output area.
62
To Next Page
Loading...
