Suggested solutionsProblem
The system requires approximately 2 minutes when switching print
modes in order to make any necessary adjustments for the next
print job, including color-to-color registration, density, charge levels,
bias levels, or other adjustments.
• The system has two print modes selectable at the print server:
- 4 Color Mode (CMYK: Cyan, Magenta, Yellow, Black)
- Black and White Mode Only
• If the next print job is switching print modes, for example from
black-only to 4-color, the system requires approximately 2
minutes to make any necessary adjustments.
• During this time, the touch screen displays the Adjusting Image
Quality message.
• The next job begins printing once the system completes its
adjustments.
Other information to remember includes:
• From a cold start (power on or power saver), system takes less
than 5 minutes to start printing.
• From standby mode, system usually takes less than 1 minute
to start printing.
The press is taking longer
than one minute before
printing the next job.
Check the application or print driver settings on whether non-
standard fonts are being used for printing.
Text prints incorrectly (text
is corrupted).
• At the UI, check the paper settings for the tray (Machine
Status > Device Information > Paper Tray Status).
• Check the print server settings.
• Check that the paper is loaded correctly as either SEF or LEF
and this matches the paper settings programmed at the print
server.
Trays do not recognize the
media.
Xerox
®
Versant
®
80 Press14-4
User Guide
Press Problem Solving
To Next Page
Loading...
