Xerox Versant 80 Press - Page 180

Recommended solutionPossible causeFault codeFault Area
Reseat the Drum Unit (Y);
Switch Drum Units; If prob-
lem persists, replace Drum
Unit (Y).
CRUM data is damaged091-920, 091-
924
Reseat the Drum Unit (M);
Switch Drum Units; If prob-
lem persists, replace Drum
Unit (M).
CRUM data is damaged091-922, 091-
925
Reseat the Drum Unit (C);
Switch Drum Units; If prob-
lem persists, replace Drum
Unit (C).
CRUM data is damaged091-923, 091-
926
Reseat the Drum Unit (K);
Switch Drum Units; If prob-
lem persists, replace Drum
Unit (K).
CRUM data is damaged091-915, 091-
916
Power Off/On the press.
If error persists, contact the
Customer Support Center.
Software error092-333Process Control
Replace/Reinsert Cartridge.
Ensure Doors are closed.
Power Off/On the press. Con-
tact Customer Support.
Dry Ink/Toner Cartridge093-3[00-99],
093-4[00-99],
093-6[00-99],
093-9[00-99]
Power Off/On the press.
If error persists, contact the
Customer Support Center.
Transfer Belt or Roll fault094-312, 094-
318
Transfer
Fuser Belt Assembly is out of
position. Reseat the assembly
and make sure the Belt Edge
Sensor is in contact with the
belt edge.
Fuser Belt in Limit Fail099-339
Power Off/On the press.
If error persists, contact the
Customer Support Center.
General Fuser faults099-[000-
999]
Fuser Belt Assembly is out of
position. Reseat the assembly
and make sure the Belt Edge
Sensor is in contact with the
belt edge.
Fuser Belt Out Limit Fail099-340
Xerox
®
Versant
®
80 Press14-18
User Guide
Press Problem Solving