Recommended SolutionPossible CauseFault CodeFault Area
1. Fan the paper to eliminate pa-
per adhesion (especially in high
humidity or high temperature
environments).
2. Clean the Bypass Tray feed, re-
tard, and nudger rolls with a
damp cloth.
3. Replace feed rolls (feed, retard,
nudger); refer to Replacing the
Bypass Tray Feed Rolls for the
OHCF (Trays 8 and 9).
4. If problem persists, Call for ser-
vice.
Repetitive misfeeds or
multifeeds
178-120, 078-
125, 078-126,
078-127
Bypass (Tray
5)
Perform the following in this order:
1. Remove or clear any jammed
paper.
2. Replace and fan the paper in
tray.
3. Replace the OHCF Feed Rolls;
refer to Replacing the OHCF
Feed Rolls for the OHCF (Trays
8 and 9).
Pre-registration sensor
jam; during paper
transportation, feed
sensor is not turned on
within period of time
paper is transporting
from tray
178-100, 178-
101
Tray 8
178-103Trays 5 (By-
pass), 8, and
9
1. Fan the paper to eliminate pa-
per adhesion (especially in high
humidity or high temperature
environments).
2. Check the position of Skew Ad-
justment Levers. The levers
should be retracted.; refer to
Skew Adjustment Levers (Trays
8 and 9).
3. Replace the tray feed rolls (feed,
retard, nudger); refer to Repla-
cing the OHCF Feed Rolls for the
OHCF (Trays 8 and 9).
4. If problem persists, Call for ser-
vice.
Repetitive misfeeds or
multifeeds
078-125, 078-
126, 078-127,
178-106, 178-
156
Trays 8 and 9
14-23Xerox
®
Versant
®
80 Press
User Guide
Press Problem Solving
To Next Page
Loading...
