06/2014
6-15
WC 5022/5024
6.1.20 Image Loss
General
Version 1.0
6.1.20 Image Loss
Each paper size has the following image loss.
• Lead Edge: 4 +/-1.5 mm or shorter
• Side Edge: 4 +/-1.5 mm or shorter
To adjust the Edge Erase amount, refer to [ADJ 18.1.3 Edge Erase Value Adjustment] in
Chapter 4 of the Service Manual.
6.1.21 Print Area
6.1.21.1 Paper Sizes that Can be Transported
The minimum and maximum paper sizes that can be transported in the Main Unit are as fol-
lows:
• Minimum transportable paper size:
– Width IOT/STM/2TM: 148.5 mm (A5 SEF), MSI: 127 mm (Non-Standard Size)
– Length MSI: 98 mm (Non-Standard Size)
• Maximum transportable paper size:
– Width: 297.0 mm (A3)
– Length: 431.8. mm (11x17)
6.1.21.2 Maximum Print Area
The printable area defines the area where the image can be printed. The maximum printable
area of the Main Unit is as follows.
• Maximum printable area: 297.0 mm wide x 425.8 mm long
6.1.21.3 Maximum Print Guaranteed Area
The area where the image quality is guaranteed is referred to as Print Guaranteed Area. The
Print Guaranteed Area of the Main Unit is as follows.
• Maximum print guaranteed area: 289.0 mm wide x 423.4 mm long
However, this print area is fully applied only when the Copy Job and Print Job uses paper
with size A3 SEF in width direction or 11x17" SEF in length direction.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
