YASKAWA L1000A - Changing Parameter Settings or Values

4.3 The Drive and Programming Modes
100 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
◆ Changing Parameter Settings or Values
This example explains changing C1-02 (Deceleration Ramp 1) from 1.50 seconds (default) to 2.50 seconds.
Step Display/Result
1. Turn on the power to the drive. The initial display appears.
2.
Press or until the Parameter Setting Mode screen appears.
3.
Press to enter the parameter menu tree.
4.
Press or to select the C parameter group.
5.
Press two times.
6.
Press or to select the parameter C1-02.
7.
Press to view the current setting value (1.5 s). The left most digit flashes.
8.
Press , or until the desired number is selected. “1” flashes.
9.
Press and enter 0020.0.
10.
Press to confirm the change.
11. The display automatically returns to the screen shown in Step 4.
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
FWD FWD/REV
HELP
- MODE - PRG
DATA
Programming
FWD
←→
-PRMSET-
Initialization
Select Language
PRG
FWD
A1-00=0
←→
-PRMSET-
Basic Setup
Accel Ramp 1
PRG
FWD
C1-01 = 1.50 sec
←→
-PRMSET-
Accel/Decel
Accel Ramp 1
PRG
FWD
C1-01= 1.50 sec
-PRMSET-
C1-01= 1.50 sec
(0.0~600.00)
“1.50 sec”
PRG
Accel Ramp 1
←→
FWD
φψ
-PRMSET-
C1-02= 1.50 sec
(0.0~600.00)
“1.50 sec”
PRG
Decel Ramp 1
FWD
-PRMSET-
C1-02= 001.50 sec
(0.0~600.00)
“1.50 sec”
PRG
Decel Ramp 1
←→
FWD
F1
left
F2
right
-PRMSET-
C1-02=001.50 sec
(0.0~600.00)
“1.50 sec”
PRG
Decel Ramp 1
←→
FWD
-PRMSET-
C1-02=002.50 sec
(0.0~600.00)
“1.50 sec”
PRG
Decel Ramp 1
←→
FWD
Entry Accepted
φψ
-PRMSET-
C1-02= 2.50 sec
(0.0~600.00)
“1.50 sec”
PRG
Decel Ramp 1
FWD
SIEP_C710616_38F_5_0.book 100 ページ ２０１５年１１月９日 月曜日 午後３時３６分