YASKAWA L1000A - This Appendix Contains a Full Listing of All Parameters and Settings Available in the Drive.; Understanding the Parameter Table

392 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
B.1 Understanding the Parameter Table
B.1 Understanding the Parameter Table
◆ Control Modes, Symbols, and Terms
The table below lists terms and symbols used in this section to indicate which parameters are available in which control
modes.
Note: Refer to Control Mode Selection on page 28 for detailed instructions on each control mode.
Table B.1 Symbols and Icons Used in the Parameter Table
Note: If a parameter is not available in a certain control mode, the symbol for that control mode is grayed out.
Symbol Description
Parameter is available in all control modes.
Parameter is available when operating the drive with V/f Control.
Parameter is available when operating the drive with Open Loop Vector.
Parameter is available when operating the drive with Closed Loop Vector.
Parameter is available when operating the drive with Closed Loop Vector for PM motors.
Parameter can be changed during run.
Motor 2 Refers to a second motor when the drive is operating two motors. Switch between these motors using the multi-function input terminals.
All Modes
V/f
OLV
CLV
CLV/PM
SIEP_C710616_38F_5_0.book 392 ページ ２０１５年１１月９日 月曜日 午後３時３６分