YASKAWA L1000A - Terminal Cover

3.5 Terminal Cover
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual 63
Electrical Installation
3
3.5 Terminal Cover
Follow the procedure below to remove the terminal cover for wiring and to reattach the terminal cover after wiring is
complete.
◆ Removing/Reattaching the Terminal Cover
■ Removing the Terminal Cover
Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027
1. Loosen the terminal cover screw using a #2 Phillips screwdriver. Screw sizes vary by drive model.
Figure 3.3
Figure 3.4 Removing the Terminal Cover
2. Push in on the tab located on the bottom of the terminal cover and gently pull forward to remove the terminal
cover.
Figure 3.4
Figure 3.5 Removing the Terminal Cover
Models CIMR- LU20085 to 20415, 40045 to 40605, and 50003 to 50027
1. Loosen the screws on the terminal cover, then pull down on the cover.
CAUTION! Do not completely remove the cover screws, just loosen them. If the cover screws are removed completely, the terminal
cover may fall off causing an injury.
Note: The shape of the terminal covers and the numbers of screws differ depending on the drive models. Refer to Component Names on
page 31 for details.
Figure 3.5
Figure 3.6 Removing the Terminal Cover
YEA_common
YEA_common
YEA_common
SIEP_C710616_38F_5_0.book 63 ページ ２０１５年１１月９日 月曜日 午後３時３６分