YASKAWA L1000A - D.3 UL and CSA Standards

D.3 UL and CSA Standards
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual 481
Standards Compliance
D
D.3 UL and CSA Standards
◆ UL Standards Compliance
The UL/cUL mark applies to products in the United States and Canada. It indicates that UL has performed product testing
and evaluation, and determined that their stringent standards for product safety have been met. For a product to receive
UL certification, all components inside that product must also receive UL certification.
Figure D.7
Figure D.7 UL/cUL Mark
This drive is tested in accordance with UL standard UL508C and complies with UL requirements. To ensure continued
compliance when using this drive in combination with other equipment, meet the following conditions:
■
Installation Area
Do not install the drive to an area greater than pollution degree 2 (UL standard).
■
Ambient Temperature
IP00 enclosure with top protective cover: -10 to +40°C (14 to 104°F)
IP00 enclosure: -10 to +50°C (14 to 122°F)
■
Main Circuit Terminal Wiring
Yaskawa recommends using closed-loop crimp terminals on all drive models. UL/cUL approval requires the use of UL
Listed closed-loop crimp terminals when wiring the drive main circuit terminals on models CIMR-LU20085 through
20415, 40045 through 40605, and 50032 to 50200. Use only the tools recommended by the terminal
manufacturer for crimping.
The wire gauges listed in Table D.4 and Table D.5 are Yaskawa recommendations. Refer to local codes for proper wire
gauge selections.
Table D.4 Wire Gauge and Torque Specifications (Three-Phase 200 V Class)
Model
CIMR-LU
Terminal
Recommended Gauge
AWG, kcmil
Applicable Gauge
AWG, kcmil
Screw
Size
Tightening Torque
Nm (lb.in.)
20008
R/L1, S/L2, T/L3 14 14 to 10
M4
1.2 to 1.5
(10.6 to 13.3)
U/T1, V/T2, W/T3 14 14 to 10
–, +1, +2 – 14 to 10
B1, B2 – 14 to 10
10
<1> 14 to 10
20011
R/L1, S/L2, T/L3 12 14 to 10
M4
1.2 to 1.5
(10.6 to 13.3)
U/T1, V/T2, W/T3 14 14 to 10
–, +1, +2 – 14 to 10
B1, B2 – 14 to 10
10
<1> 14 to 10
20014
R/L1, S/L2, T/L3 10 12 to 10
M4
1.2 to 1.5
(10.6 to 13.3)
U/T1, V/T2, W/T3 10 14 to 10
–, +1, +2 – 14 to 10
B1, B2 – 14 to 10
10
<1> 14 to 10
SIEP_C710616_38F_5_0.book 481 ページ ２０１５年１１月９日 月曜日 午後３時３６分