YASKAWA L1000A - Connecting Peripheral Devices

8.3 Connecting Peripheral Devices
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual 355
Peripheral Devices & Options
8
8.3 Connecting Peripheral Devices
Figure 8.1 illustrates how to configure the drive and motor to operate with various peripheral devices.
Refer to the specific manual for the devices shown below for more detailed installation instructions.
Figure 8.1
Figure 8.1 Connecting Peripheral Devices
<1> To obtain the driver and software of USB Copy Unit, CopyUnitManager and DriveWizardPlus, access the Yaskawa website at
http://www.yaskawa.com
Note: If the drive is set to trigger a fault output when the fault reset function is activated (L5-02 = 1), then a sequence to interrupt power
on a fault will shut off power to the drive when the drive attempts to restart. The default setting for L5-02 is 0 (fault output active
during restart attempt).
Copy
Verify
Read
LOCK
YASKAWA
JVOP-181
USB Copy Unit
COM ERR
PC
DriveWizard
Engineering Software Tools
Power
Supply
Molded Case
Circuit Breaker
(MCCB)
or
Electric Leakage
Circuit Breaker
(ELCB)
Magnetic
Contactor
(MC)
Surge
Absorber
DC Link
Choke
AC Reactor
Zero-phase
Reactor
Fuse
Input Side
Noise Filter
Magnetic
Contactor
(switches to
line power)
Zero-phase
Reactor
Thermal Relay
Braking Resistor Unit
Output Side
Noise Filter
Drive
Ground
B1 B2
Motor
U/T1V/T2W/T3R/L1 S/L2
+2
+1
T/L3
Ground
USB Copy unit
USB Cable
(Type-AB, sold separately)
LED Operator/LCD Operator
USB Cable
(Type-AB)
Braking Unit
−
+3
24 V control
power supply
unit
<1>
<1>
YEA_
TMon
ly
SIEP_C710616_38F_5_0.book 355 ページ ２０１５年１１月９日 月曜日 午後３時３６分