YASKAWA L1000A - O2: Digital Operator Keypad Functions

5.10 o: Operator Related Settings
252 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
■ o1-22: Mechanical Gear Ratio
Sets the gear ratio of the mechanical gear.
■
o1-23: HBB Non Display Select
Shows or hides the HBB command on the digital operator while the safety signal is being input.
Setting 0: Show HBB
HBB is displayed on the digital operator while the safety signal is being input.
Setting 1: Hide HBB
HBB is not displayed on the digital operator while the safety signal is being input.
◆ o2: Digital Operator Keypad Functions
These parameters determine the functions assigned to the operator keys.
■
o2-01: LO/RE (LOCAL/REMOTE) Key Function Selection
Parameter o2-01 determines whether the LO/RE key on the digital operator will be enabled or not for switching between
LOCAL and REMOTE.
Setting 0: Disabled
The LO/RE key is disabled.
Setting 1: Enabled
The LO/RE switches between LOCAL and REMOTE operation. Switching is possible during stop only. When LOCAL is
selected, the LED indicator on the LO/RE key will light up.
■
o2-02: STOP Key Function Selection
Determines if the STOP key on the digital operator can still be used to stop drive operation when the drive is being
controlled from a remote source (i.e., not from digital operator).
Setting 0: Disabled
Setting 1: Enabled
The STOP key will terminate drive operation even if the Up/Down command source is not assigned to the digital
operator. Cycle the Up/Down command to restart the drive if the drive has been stopped by pressing the STOP key.
No.
<1> The setting range changes depending on drive software versions.
PRG: 7017 or earlier: 0.10 to 50.00
PRG: 7200 or later: 0.10 to 100.00
Parameter Name Setting Range Default
o1-22 Mechanical Gear Ratio <1> Determined by A1-02
No.
<1> Available in drive software versions PRG: 7200 or later.
Parameter Name Setting Range Default
o1-23 <1> HBB Non Display Select 0 or 1 0
No. Parameter Name Setting Range Default
o2-01 LO/RE Key Function Selection 0 or 1 0
No. Parameter Name Setting Range Default
o2-02 STOP Key Function Selection 0 or 1 0
SIEP_C710616_38F_5_0.book 252 ページ ２０１５年１１月９日 月曜日 午後３時３６分