EasyManua.ls Logo

YASKAWA L1000A - LCD Display

YASKAWA L1000A
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4.2 Using the Digital Operator
94 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
LCD Display
Figure 4. 2
Figure 4.2 LCD Display
Table 4.1 Display and Contents
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the drive is ready to run.
4 Data Display Displays specific data and operation data.
5
Speed Reference Source
Assignment
<1>
<1> Displayed when in Drive Mode.
OPR Displayed when the speed reference source is assigned to the LCD Operator.
COM Displayed when the speed reference source is assigned to MEMOBUS/Modbus Communication.
OP Displayed when the speed reference is assigned to an option card.
6
LO/RE
Display
<2>
<2> Displayed when in Drive Mode and Monitor Mode.
RSEQ Displayed when the Up/Down command is supplied from a remote source.
LSEQ Displayed when the Up/Down command is supplied from the operator keypad.
RREF Displayed when the speed reference is supplied from a remote source.
LREF Displayed when the speed reference is supplied from the operator keypad.
7
Function Key 1
(F1)
HELP
Pressing displays the Help menu.
Pressing scrolls the cursor to the left.
HOME
Pressing returns to the top menu (Speed Reference).
ESC
Pressing returns to the previous display.
8FWD/REV
FWD During Up command
REV During Down command
9
Function Key 2
(F2)
FWD/REV
Pressing switches between Up and Down when the Up/Down command is set from the digital operator.
DATA
Pressing scrolls to the next display.
Pressing scrolls the cursor to the right.
RESET
Pressing resets the existing drive fault or error.
- MODE -
U1-01= 0.00%
U1-02= 0.00%
U1-03= 0.00A
DRV
Speed Ref (OPR)
Rdy
RSEQ
LREF
FWD
FWD/REV
6
5
4
123
789
YEA_common
F1
F1
F1
F1
F1
F1
F1
F1
SIEP_C710616_38F_5_0.book 94 ペー 2015年11月9日 月曜日 午後3時36

Table of Contents

Other manuals for YASKAWA L1000A

Related product manuals