YASKAWA L1000A - Page 64

3.5 Terminal Cover
64 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
2. Pull forward on the terminal cover to free it from the drive.
Figure 3. 6
Figure 3.7 Removing the Terminal Cover
■ Reattaching the Terminal Cover
Models CIMR-LU20008 to 20075, 40005 to 40039, and 50003 to 50027
Power lines and signal wiring should pass through the opening provided. Refer to Wiring the Main Circuit Terminal on
page 77 and Wiring the Control Circuit Terminal on page 81 for details on wiring.
NOTICE: Equipment Hazard. Separate motor and/or braking circuit wiring (terminals, U/T1, V/T2, W/T3, +3, +2, +1,(-), B1, B2, from all
other wiring. Place motor wiring within its own conduit or cable tray with appropriate divider, and use shielded motor cable where
appropriate. Improper wiring practices could result in malfunction of drive due to electrical interference.
Reattach the terminal cover after completing the wiring to the drive and other devices.
Figure 3. 7
Figure 3.8 Reattaching the Terminal Cover
Models CIMR- LU20085 to 20415, 40045 to 40605, and 50003 to 50027
After wiring the terminal board and other devices, double-check connections and reattach the terminal cover. Refer to
Wiring the Main Circuit Terminal on page 77 and Wiring the Control Circuit Terminal on page 81 for details on
wiring.
Figure 3. 8
Figure 3.9 Reattaching the Terminal Cover
YEA_common
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
Power lines and signal wiring
exit through the opening provided.
YEA_common
Connect ground wiring first,
followed by the main circuit,
and then wire the control circuit.
YEA_common
SIEP_C710616_38F_5_0.book 64 ページ ２０１５年１１月９日 月曜日 午後３時３６分