3 System Startup
3.2.2 Operation
3-36
2. Right-click the H02 drawing in the High Scan Programs Folder and select Open – Tuning Panel.
3. The Tuning Panel Window for the H02 drawing will be displayed.
The details on the Tuning Panel Window display are shown in the following table.
Input position and current value.
No.
　
Data Name
S Display Definition Current Value Unit Lower limit Upper Limit REG-NO. DWG
1
∗∗∗∗∗∗∗∗∗∗∗∗∗
Common monitor
∗∗∗∗∗∗∗∗∗∗∗∗∗∗
XXXXX 00000 00000 32767 DW00010 L
2 Axis 1 operation ready ON/OFF OFF IB80000
3 Axis 2 operation ready ON/OFF OFF IB80000
4 Axis 1 current position XXXXXXXXXX 0000000000
-2147483648
2147483647 IL8016
5 Axis 2 current position XXXXXXXXXX 0000000000
-2147483648
2147483647 IL8096
6
∗∗∗∗∗∗∗∗∗∗∗∗∗
Common operation
∗∗∗∗∗∗∗∗∗∗∗∗∗∗
XXXXX 00000 00000 32767 DW00010 L
7 Servo ON PB S ON/OFF OFF MB300000
8 Alarm reset PB S ON/OFF OFF MB300001
9
∗∗∗∗∗∗∗∗
Manual operation and setting
∗∗∗∗∗∗∗∗∗
XXXXX 00000 00000 32767 DW00010 L
10 Axis 1 forward JOG S ON/OFF OFF DB000010 H02.01
11 Axis 1 reverse JOG S ON/OFF OFF DB000011 H02.01
12 Axis 2 forward JOG S ON/OFF OFF DB000010 H02.02
13 Axis 2 reverse JOG S ON/OFF OFF DB000011 H02.02
14 Axis 1 forward STEP S ON/OFF OFF DB000012 H02.01
15 Axis 1 reverse STEP S ON/OFF OFF DB000013 H02.01
16 Axis 2 forward STEP S ON/OFF OFF DB000012 H02.02
17 Axis 2 reverse STEP S ON/OFF OFF DB000013 H02.02
18 Axis 1 STEP moving amount S XXXXXXXXXX 0000000000 -2147483648 2147483647 DL00010 H02.01
19 Axis 2 STEP moving amount S XXXXXXXXXX 0000000000 -2147483648 2147483647 DL00010 H02.02
To Next Page
Loading...
Need help?
General
