Yealink SIP-T58V/A

Administrator’s Guide for SIP-T5 Series Smart Media Phones
228
files.
You can ask the distributor or Yealink FAE for dial-now template. You can also obtain the
dial-now template online:
http://support.yealink.com/documentFront/forwardToDocumentFrontDisplayPage. For more
information on obtaining the dial-now template, refer to Obtaining Configuration Files and
Resource Files on page 114.
When editing a dial-now template, learn the following:
 <DialNow> indicates the start of a template and </DialNow> indicates the end of a
template.
 When specifying the desired line(s) for the dial-now rule, the valid values are 0 and line ID.
Multiple line IDs are separated by commas.
The following table lists valid values of line ID for each phone model.
Phone Model
Values
Description
SIP-T58V/T58A/T56A
0~16
0 stands for all lines
1~16 stand for line1~line16
 At most 100 rules can be added to the IP phone.
The expression syntax in the dial-now rule template is the same as that introduced in the section
Dial Plan on page 219.
To customize a dial-now template:
1. Open the template file using an ASCII editor.
2. Create dial-now rules between <DialNow> and </DialNow>.
For example:
<Data DialNowRule="1001" LineID="0" />
Where:
DialNowRule="" specifies the dial-now rule.
LineID="" specifies the desired line(s) for this rule. When you leave it blank or enter 0, this
dial-now rule will apply to all lines.
If you want to change the dial-now rule, specify the values within double quotes.
3. Save the change and place this file to the provisioning server.