Administrator’s Guide for SIP-T5 Series Smart Media Phones
286
To configure auto redial via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Auto Redial.
3. Enter the waiting time in the Auto Redial Interval (1~300s) field.
The default waiting time is 10s.
4. Enter the desired times in the Auto Redial Times (1~300) field.
The default value is 10.
5. Click Confirm to accept the change.
To configure auto redial via phone user interface:
1. Tap Settings->Features->Auto Redial.
2. Tap the On radio box in the Auto Redial field.
3. Enter the waiting time (in seconds) in the Redial Interval field.
4. Enter the desired times in the Redial Times field.
5. Tap to accept the change.
Auto Answer
Auto answer allows IP phones to automatically answer an incoming call. IP phones will not
automatically answer the incoming call during a call even if auto answer is enabled. Auto
answer is configurable on a per-line basis. Auto-Answer delay defines a period of delay time
before the IP phone automatically answers incoming calls.
Auto Answer Tone
Auto answer tone allows the IP phone to play a tone when an incoming call is automatically
answered. You can customize the auto answer tone or select specialized tone sets (vary from
country to country) for your IP phone. For more information, refer to Tones on page 594.
Note
Auto answer is not applicable to automatically answer an IP address call. Automatically answering
an IP address call works only if IP direct auto answer feature is enabled. For more information,
refer to IP Direct Auto Answer on page 290.
To Next Page
Loading...
Need help?
General
