Yealink SIP-T58V/A

Configuring Advanced Features
239
Parameters
Permitted Values
Default
If the value of the parameter “dialplan.digitmap.string” is set to <[2-9]x:86>3.T|0T, the IP
phone will wait 5 seconds before matching the entered digits to this dial plan and placing
the call.
 Distribution configuration (configure a string of positive integers separated by “|” for each
string of the digit map in the corresponding position)
If there are more digit maps than timeout values, the last timeout is applied to the extra digit
map. If there are more timeout values than digit maps, the extra timeout values are ignored.
Example:
dialplan.digitmap.interdigit_short_timer = 4|5|3|6|2|1
If the value of the parameter “dialplan.digitmap.string” is set to
<[2-9]x:86>3.T|2T|1xxT|0x.!|[2-9]11T, 4 is applied to the “<[2-9]x:86>3.T” digit map, 5 is
applied to “2T” digit map, 3 is applied to “1xxT” digit map, 6 is applied to “0x.!” digit map, 2
is applied to the “[2-9]11T” digit map, the last digit 1 is ignored.
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.interdigit_short_timer” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface:
None
dialplan.digitmap.no_match_action
0, 1 or 2
0
Description:
Configures the behavior when an impossible digit map match occurs.
0-prevent users from entering a number and immediately dial out the entered numbers
1-the dialing will fail and the LCD screen will prompt “Forbidden Number”
2-allow users to accumulate digits and dispatch call manually with the send key or
automatically dial out the entered number after a certain period of time configured by the
parameter “dialplan.digitmap.interdigit_long_timer”
Note: It works only if the value of the parameter “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.no_match_action” takes precedence over that
configured by this parameter.
Web User Interface:
None
Phone User Interface: