Yealink SIP-T58V/A

Setting Up Your System
29
static.network.ip_address_mode
static.network.internet_port.ip
static.network.internet_port.mask
static.network.internet_port.gateway
static.network.primary_dns
static.network.secondary_dns
Web User Interface
Configure network parameters of the IP
phone manually.
Navigate to:
http://<phoneIPAddress>/servlet?m=mod_
data&p=network&q=load
Phone User Interface
Configure network parameters of the IP
phone manually.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
static.network.internet_port.type
0, 1 or 2
0
Description:
Configures the Internet port type for IPv4.
0-DHCP
1-PPPoE
2-Static IP Address
Note: It works only if the value of the parameter “static.network.ip_address_mode” is set to 0
(IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the IP phone will reboot to make the
change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4->Type
static.network.ip_address_mode
0, 1 or 2
0
Description:
Configures the IP address mode.
0-IPv4
1-IPv6
2-IPv4 & IPv6