Yealink SIP-T58V/A User Manual

Configuring Advanced Features
497
Parameters
Permitted Values
Default
Configures the channel of the multicast paging group in the paging list.
If it is set to 0, all the Yealink IP phones running old firmware version (old paging
mechanism) or prior or Yealink IP phones listens to channel 0 or third-party available
devices (e.g., Cisco IP phones) in the paging group can receive the RTP stream.
If it is set to 1 to 25, the Polycom or Yealink IP phones preconfigured to listen to the
channel can receive the RTP stream.
It it is set to 26 to 30, the Yealink IP phones preconfigured to listen to the channel can
receive the RTP stream.
Example:
multicast.paging_address.1.channel = 3
multicast.paging_address.2.channel = 5
Web User Interface:
Directory->Multicast IP->Paging List->Channel
Phone User Interface:
Settings->Features->Paging List->Option->Edit->Channel
Multicast Paging Key
For more information on how to configure the DSS Key, refer to Appendix D: Configuring DSS
Key on page 750.
Details of Configuration Parameters:
Parameters
Permitted
Values
Default
linekey.X.type/ expansion_module.X.key.Y.type
24
Refer to the
following
content
Description:
Configures a DSS key as a multicast paging key on the IP phone.
The digit 24 stands for the key type Multicast Paging.
For line keys:
X ranges from 1 to 27.
For ext keys:
X ranges from 1 to 3, Y ranges from 1 to 60.
Example:
linekey.2.type = 24

Yealink SIP-T58V/A Specifications

General

Brand	Yealink
Model	SIP-T58V/A
Category	IP Phone
Language	English