Yealink SIP-T58V/A

Setting Up Your System
35
Parameters
Permitted
Values
Default
Note: It works only if the value of the parameter “static.network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6). If you change this parameter, the IP phone will reboot to make
the change take effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4->Type
static.network.pppoe.user
String within
32 characters
Blank
Description:
Configures the user name for PPPoE connection.
Example:
static.network.pppoe.user = Xmyl0592123
Note: It works only if the value of the parameter “static.network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6), and “static.network.internet_port.type” is set to 1 (PPPoE). If you
change this parameter, the IP phone will reboot to make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config->PPPoE->User Name
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4->Type
(PPPoE) ->PPPoE User
static.network.pppoe.password
String within
99 characters
Blank
Description:
Configures the password for PPPoE connection.
Example:
static.network.pppoe.password = yealink123
Note: It works only if the value of the parameter “static.network.ip_address_mode” is set to
0 (IPv4) or 2 (IPv4 & IPv6), and “static.network.internet_port.type” is set to 1 (PPPoE). If you
change this parameter, the IP phone will reboot to make the change take effect.
Web User Interface:
Network->Basic->IPv4 Config->PPPoE->Password
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4->Type
(PPPoE) ->PPPoE Password