Yealink SIP-T58V/A

Administrator’s Guide for SIP-T5 Series Smart Media Phones
548
Parameters
Permitted Values
Default
Description:
Enables or disables the IP phone to receive the action URI requests.
0-Disabled
1-Enabled
Web User Interface:
None
Phone User Interface:
None
features.show_action_uri_option
0 or 1
1
Description:
Enables or disables the phone to pop up the Allow Remote Control prompt.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the phone will not pop up the Allow Remote Control prompt
when receiving an HTTP or HTTPS GET request, or receiving a SIP NOTIFY message with the
“Event: ACTION-URI” header. The phone will directly perform the specified action.
Note: It works only if the value of the parameter “features.action_uri.enable” is set to 1
(Enabled).
Web User Interface:
None
Phone User Interface:
None
features.action_uri_limit_ip
IP address or any
Blank
Description:
Configures the IP address of the server from which the IP phone receives the action URI
requests.
For discontinuous IP addresses, multiple IP addresses are separated by commas.
For continuous IP addresses, the format likes *.*.*.* and the “*” stands for the values 0~255.
For example: 10.10.*.* stands for the IP addresses that range from 10.10.0.0 to
10.10.255.255.
If left blank, the IP phone will reject any HTTP GET request.
If it is set to “any”, the IP phone will accept and handle HTTP GET requests from any IP