Yealink SIP-T58V/A - Page 619

Configuring Audio Features
597
oad
Details of Configuration Parameters:
Parameters
Permitted Values
Default
voice.tone.country
Refer to the
following content
Custom
Description:
Configures the country tone for the IP phone.
Permitted Values:
Custom, Australia, Austria, Brazil, Belgium, Chile, China, Czech, Czech ETSI, Denmark, Finland,
France, Germany, Great Britain, Greece, Hungary, Lithuania, India, Italy, Japan, Mexico, New
Zealand, Netherlands, Norway, Portugal, Spain, Switzerland, Sweden, Russia, United States.
Example:
voice.tone.country = Custom
Web User Interface:
Settings->Tones->Select Country
Phone User Interface:
None
voice.tone.dial
String
Blank
Description:
Customizes the dial tone.
tonelist = element[,element] [,element]…
Where
element = [!]Freq1[+Freq2][+Freq3][+Freq4] /Duration
Freq: the frequency of the tone (ranges from 200 to 4000Hz). If it is set to 0Hz, it means the
tone is not played.
A tone is comprised of at most four different frequencies.
Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.
You can configure at most eight different tones for one condition, and separate them by
commas. (e.g., 250/200,0/1000,200+300/500,200+500+800+1500/1000).
If you want the IP phone to play tones once, add an exclamation mark “!” before tones
(e.g., !250/200,0/1000,200+300/500,200+500+800+1500/1000).
Note: It works only if the value of the parameter “voice.tone.country” is set to Custom.
Web User Interface:
Settings->Tones->Dial
Phone User Interface: