Setting Up Your System
51
(Enabled). If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Advanced->LLDP->Packet Interval (1~3600s)
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->LLDP->Packet Interval
To configure LLDP feature via web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.
3. Enter the desired time interval in the Packet Interval (1~3600s) field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the phone.
To configure LLDP feature via phone user interface:
1. Tap Settings->Advanced (default password: admin) ->Network->LLDP.
2. Tap the On radio box in the LLDP Status field.
3. Enter the priority value (1-3600s) in the Packet Interval field.
4. Tap to accept the change.
The phone prompts you to reboot the phone.
5. Tap OK to reboot the phone.
To Next Page
Loading...
