Yealink SIP-T58V/A

Administrator’s Guide for SIP-T5 Series Smart Media Phones
66
Network->Basic->IPv6 Config->Static IP Address->Primary DNS
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->WAN Port->IPv6->Type
(Static IP) ->Primary DNS
Or Settings->Advanced (default password: admin) ->Network->WAN Port->IPv6->Type
(DHCP) ->Static DNS (Enabled) ->Primary DNS
static.network.ipv6_secondary_dns
IPv6 address
Blank
Description:
Configures the secondary IPv6 DNS server.
Example:
static.network.ipv6_secondary_dns = 2026:1234:1:1:c3c7:c11c:5447:23a6
Note: It works only if the value of the parameter "static.network.ip_address_mode" is set
to 1 (IPv6) or 2 (IPv4 & IPv6). In DHCP environment, you also need to make sure the
value of the parameter "static.network.ipv6_static_dns_enable" is set to 1 (On). If you
change this parameter, the IP phone will reboot to make the change take effect.
Web User Interface:
Network->Basic->IPv6 Config->Static IP Address->Secondary DNS
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->WAN Port->IPv6->Type
(Static IP) ->Secondary DNS
Or Settings->Advanced (default password: admin) ->Network->WAN Port->IPv6->Type
(DHCP) ->Static DNS (Enabled) ->Secondary DNS
static.network.ipv6_icmp_v6.enable
0 or 1
1
Description:
Enables or disables the IP phone to obtain IPv6 network settings via SLAAC (Stateless
Address Autoconfiguration) method.
0-Disabled
1-Enabled
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->ICMPv6 Status->Active
Phone User Interface:
None