Zumtobel LITECOM - Page 33

Commissioning
LITECOM, Commissioning and maintenance instructions 17.0 | 04.2024 | en 32
Step 2: configure the control device for the first time
i
Note
The following configuration options are available: Select settings, Apply current settings, Restore
data backup.
· Select settings: a wizard guides you through all the configuration steps. Select this option if you
are connecting to the LITECOM CCD control device for the first time or have reset to the factory
settings. Proceed to step 2a .
· Apply current settings: a summary of the existing configuration is displayed and is applied
without further editing. Select this option if you are updating from a previous version to software
version 3.5.0 or higher and wish to apply the existing settings. Proceed to step 2b .
· Restore data backup: you can load a data backup. Select this option if you are updating from a
previous version to software version 3.5.0 or higher and wish to apply the settings from a
previously created data backup. Proceed to step 2c .
Step 2a: select settings
1. Tap the Select settings option.
2. Tap the Next button.
ÜThe Control device view is displayed.
i
Note
Information and notes on the following settings (network settings, date
and time, geographical settings) can be found in the respective sections
in the basic settings.
For more information see Section Basic settings
3. Enter a device name.
4. Enter a device designation.
32
35
35
53