3Com Baseline 2928 PWR Plus - Page 157

1-16
z Click the Trap tab and enter the page as shown in Figure 1-24.
Figure 1-24 Enable the agent to send SNMP traps
z Select the Enable SNMP Trap check-box.
z Click Apply.
# Add target hosts of SNMP traps.
z Click Add to enter the page as shown in Figure 1-25.
Figure 1-25 Add target hosts of SNMP traps
z Select the destination IP address type as IPv4.
z Type the destination address 1.1.1.2.
z Type the user name user1.
z Type the UDP port 5000.
z Select v3 from the Security Model drop-down box.
z Click Apply.
2) Configure NMS.