3Com Baseline 2928 PWR Plus - Page 274

1-23
z Select Enable from the LLDP Enable dropdown list.
z Click Apply.
2) Configure Switch B
# Enable LLDP on port GigabitEthernet 1/0/1. (Optional. By default, LLDP is enabled on Ethernet ports.)
# Set the LLDP operating mode to Rx on GigabitEthernet 1/0/1.
z Select Network > LLDP from the navigation tree to enter the Port Setup tab, as shown in Figure
1-18. Click the icon for port GigabitEthernet1/0/1. The page shown in Figure 1-19 is displayed.
Figure 1-18 The Port Setup tab
Figure 1-19 The page for configuring LLDP on the selected port
z Select Tx from the LLDP Operating Mode dropdown list.
z Click Apply.
# Enable global LLDP and configure the global LLDP setup as needed (see).