3Com Baseline 2928 PWR Plus - Page 303

1-5
Figure 1-4 Configure a default route
Make the following configurations on the page:
z Type 0.0.0.0 for Destination IP Address.
z Select 0 (0.0.0.0) from the Mask drop-down list.
z Type 1.1.4.2 for Next Hop.
z Click Apply.
# Configure a static route to Switch A and Switch C respectively on Switch B.
z After you log in to the Web interface of Switch B, select Network > IPv4 Routing from the
navigation tree and then click the Create tab to enter the page shown in
Figure 1-5.